Hi I'm attempting to hook up a Mac OSX 10.6 to a TP-Link WR740N ver 2.5 FCC V2. I can't connect to the WEB management web site through the router and my DSL which is connected won't access it. Apparently I need to contact that page to get to the CLONE MAC feature....I'm having a Catch 22 experience. Can anyone help me out? Thanks
1
Answer
by David on 2 years ago
Ever since I've upgraded my firmware on my Buffalo Router and Access Points WZR-1750DHP to the current firmware of 2.27 to fix my QOS issue my Access Points have become quite unstable. They bounce randomly throughout the day. I've called Buffalo technical support and they don't seem to care. Buffalo Tech has said that I can't 'Roll Back' to a previous firmware and all they suggested is to replace them. Replacing them with new units with older firmware wont fix my issue because then QOS will be broken. I noticed NTP was an issue in the previous firmware as well. I currently have that service disabled on my Access Points. I don't know what could be causing this problem or what to double check. Before the firmware upgrade all units were stable. They are all the same make/model.. The actual 'Master' router seems to be stable with the 2.27....just not the AP's. Ideas?
1
Answer
by Steve on 2 years ago
I recently buy a dlink router. My question is that if i connect my router to windows 10 then it will work or not?
1
Answer
by Ray on 2 years ago
I want to set Tenda wireless router and ATT speed stream DSL Modem. When I connect it logically, there is no internet connection through the DSL modem. I have the DSL to the modem, Ethernet to the router. But when I plug the desktop into the Tenda router, the modem no longer gets internet. Any suggestions would be appreciated.
1
Answer
by Ruth on 2 years ago
Copyright 2018-23 © Router Technical Support | All Rights Reserved