Are you looking forward to knowing how you can reset the password of your Buffalo LinkStation? If yes, then you have reached the right place in search of a solution. To reset the LinkStation means to bring it back to the factory default settings.
The steps that you need to carry out to reset the Buffalo LinkStation password are given below.
Step 1: Turn off your LinkStation by moving its switch downwards and wait for it to shut down.
Step 2: Turn on your LinkStation by holding down the button of function. The LED light of function will blink the white light.
Step 3: Press the button of Function when the LED light is flashing.
The settings that you need to reset are ethernet frame size, IP address, admin password and admin username. For disabling the password and the username, first you need to go to Management and then go to the option of Restore/Erase. After that, go to the Init button settings and then click on keep current admin username and password.
Step 1: Turn off the power switch by moving it downwards. This will shut down your LinkStation.
Step 2: Now, turn it back on by moving the power switch in the On position by holding down the button of function. The function LED light will start flashing blue in color.
Step 3: When the function LED starts flashing blue in color, press the button function one more time. This will begin the process of initialization. This is going to take 2-3 minutes. You will see amber light blinking at the time of initialization.
Step 4: Mentioned below are the settings that will get initialized. These include Ethernet frame size, IP address, admin password and admin username.
Step 1: Hold the button of power for three seconds for shutting down the LinkStation.
Step 2: Press the power button by pressing and holding the button of function. The function LED is going to turn blue for 60 seconds.
Step 3: If the function LED light is blinking blue in color. After that, press the function button. Then, the process of initialization is going to start. This process is going to take 2-3 minutes. After that, power LED light is going to blink amber at the time of initialization.
To take the LinkStation back to its factory default settings, then these are the instructions that you are required to follow.
Note: Please keep in mind that every setting will go back to the factory default mode. Information saved does not get erased.
Step 1: Go to settings and from there go to System and then Restore and Erase and then go to Restore Factory Defaults.
Step 2: After that, click on Restore LinkStation.
Step 3: Then, the screen of confirm operation will open up before you. After that, select the number displayed.
Step 4: The LinkStation that is going to get restored to the factory default settings.
So, these are some of the steps that you are required to carry out in order to reset the password of Buffalo LinkStation.
In order to manually reset a Buffalo NAS, these are the steps that you must perform. To factory reset your Buffalo device,
These are the simple steps that you need to carry out.
Step 1: Turn off your LinkStation.
Step 2: TRurn on your LinkStation by pressing the button function. The LED will either flash white or Blue.
Step 3: Press the function button one more time when the LED light is flashing. The Status light is either going to blink White or Blue. If it starts flashing amber, then that is the beginning of the initialization process.
These are the steps that you need to carry out in order to reset buffalo linkstation without losing data.