How to Setup D Link Router?

Set up D-link Router:

To setup a D-Link Router in your Computer then follow the steps as mentioned below:-

• To plug one end of an Ethernet cable in themodem.
• Then to plug the other end into the WAN port on the back of a D-Link wireless router.
• To connect wired computers for any Ethernet ports on the router by using another Ethernet cable.

To access the D-Link Configuration Screen follow these steps:-

• To open the web interface and type http//192.168.2.1 then press enter or return
• To use an Admin as the username and leave the password field blank when the login screen appears
• Press OK and then you should configure D-Link screen.

To set up the General Security then go to the following steps: -

• To change your administrative password then click on tools tab and to choose the Admin button.
• Press enter for a new password under the administrator heading. To confirm it and then apply. -
• To disable the wireless Local Area Network ifthere is no need to use the wireless access and make sure that no one is ableto access your network.
• Then under the home tab choose Wireless and toselect the off option.

To Enables the Wireless Encryption Protocol:-

• To Locate the Home tab in the D-Link configuration screen and then press the wireless button.
• Then to use the open system button beside Authentication.
• Then to select the enabled button next to WEPand to set the encryption key to 128 bit.
• To set the key type to ASCII and to choose a 13digit password for the key 1 field.
• And then mention the password in a securelocation. Go to apply.