Question

How To Setup TP Link Router Wr740N

I just take connection from PNPL broadband. This is a cable broadband. The connection was came from cable operator office through RJ-45 direct to my desktop LAN port and I want to split that connection to three computer. So I purchased TP-LINK router (TL-WR740N). Please someone tell me 'How to set up PNPL broadband in TP-LINK Router (TL-WR740N)' I have the IP address from cable operator I think that was a static IP.

  • Donald

  • 2

    Ans

  • 4 years ago

Answer Link
Answer - 1

TP Link wr740n Setup:

Yes you can configure your TP-Link WR740N as a repeater/wireless bridge. Following are the basic steps that you need to take to set up one:

1. Go to wireless settings page of your WR740N router's web interface and click Survey. Your bridge router will show you routers to bridge with.

2. Select the appropriate one. Make sure that the selected security settings are the one that match with the router that is connected to the ISP and provide a password for it.

3. Disable your bridge router's DHCP and restart the router.

Following these steps should allow you to setup tp link tl-wr740n router as repeater. I have been using it as one without any problem so far.

  • Published by:  Wyatt   
  •  2 years ago
Answer Link
Answer - 2

Setup TP Link Router Wr740N

Find Your TP-Link TL-WR740N Router IP Address. We need to know the Internal IP Address of your TP-Link TL-WR740N router before we can login to it.

TP-Link IP Addresses 192.168.1.1 https://tplinklogin.net If you did not see your router's ip address in the list above.

There are 2 additional ways that you can determine your router's IP address: You can either follow our How To Find Your Routers IP Address guide Or you can use our free software called Router IP Address.

Now that you have your router's Internal IP Address we are ready to login to it. Login to the TP-Link TL-WR740N Router. The TP-Link TL-WR740N has a web interface for configuration. You can use any web browser you like to login to the TP-Link TL-WR740N. Enter TP-Link TL-WR740N Internal IP Address.

Put the Internal IP Address of your TP-Link TL-WR740N in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking your for your TP-Link TL-WR740N username and password.

TP-Link TL-WR740N Default Username and Password. You need to know the username and password to login to your TP-Link TL-WR740N. All of the default usernames and passwords for the TP-Link TL-WR740N are listed below.

TP-Link Usernames TP-Link Passwords : admin admin Enter your username and password in the dialog box that pops up.

  • Published by:  Wylie   
  •  2 years ago