How to Fix the Ethernet does not have a Valid IP Configuration Error?

Fix the "Ethernet does not have a Valid IP Configuration" Error:

When Windows encounters to fix the “Ethernet does not have a valid IP configuration” error, DHCP (Dynamic Host Configuration Protocol), which allocates IP addresses to networked devices instantly, cannot provide it with an IP address.

Your computer needs an IP address to access the internet or communicate with the globe. It resembles the address of your home. A postman cannot deliver your mail if he does not know your address; the internet cannot send you anything if your IP setting is invalid.

Some things, including outdated drivers or misconfigured network configurations, could cause this issue. This simple issue can be solved by anyone with some technical knowledge. To reconnect to the internet, follow the steps below.

How to Resolve the Error "Ethernet does not have a Correct IP Configuration."

Restart Your Router

Your router's then-off switches can perform wonders. Although restarting your router may seem simple, it often resolves nine out of ten internet connectivity problems.

Be sure to wait 10 seconds after turning off your router before turning it back on. You could also restart your computer.

Network Adapter Reset

You can restart your network adapter or update your IP setup if the issue continues:

Step 1: Then select "Status" under "Settings"> "Network & Internet."

Step 2: Click "Change adapter options" under "Advanced network settings."

Step 3: "Disable" can be chosen by right-clicking the adaptor.

Step 4: Once more, right-click the adapter and choose "Enable."

Adjust the Settings on your Network Adapter

Your device automatically acquires an IP address, but it's important to verify that your settings are accurate:

Step 1: Navigate to "Control Panel" > "Network and Sharing Center" to modify the adapter settings.

Step 2: When you right-click on the Ethernet, choose "Properties."

Step 3: "Internet Protocol Version 4 (TCP/IPv4)" should be clicked twice.

Step 4: Select the "Automatically obtain an IP address" radio button.

Step 5: Choose the "Automatically retrieve DNS server address" radio button.

Step 6: Select "OK."