The rock space router web interface is the dashboard for your router; where all the settings are stored and changed. To make changes to your network you will have to do your rock space router login.
Requirements to Access the Rock Space Web Interface
Enter the rock space web interface is pretty straightforward and all you will need is:
Following are the instructions to connect to your rock space router's interface for configuration and diagnostics.
To reach the setup pages of your rock space router, you will need to be connected to its network.
So, just start by connecting to the network, either by WiFi or by ethernet cable.
Tip: If you don't know the WiFi password for your rock space router, you can always connect to it with an ethernet cable, which won't require a password.
Go to your browser and enter the router's IP address into the address field. The most common IP for rock space routers is: 192.168.1.1 If that IP address doesn't work, you can search the default rock space IP address list for your specific model.
Tip: Once you are just connected to your rock space router, you can also use whatsmyrouterip.com to fastly find the IP. It is the ‘Router Private IP’-value.
Type the Username and Password for Your Rock Space Router
Enter your current username and password in your username and password field and press sign in.
If you're not sure about the username/password you can look at the default rock space credentials to see what the defaults are, and how to reset them.
You can find the credentials printed on the label on the back of your router.
Now, you can configure anything you want on the device.
In case above login credentials doesn't work then use this method-
If these steps don't work for you and you still can't login to your router then there's another method. You identify the model name/ID of your rock space router? Now just choose your device from the box below and you will be redirected to our instructions especially for your device that adds a user manual.
When your rock space router login admin interface you should be able to change any settings that are available.
Look out when you configure your router therefore that you don't break the network.
Tip: Note down your new settings before changing anything so that you can revert it in case of trouble.
Suppose my Rock Apace Router or Network Stops Working after a Configuration Change
If you by mistake make some change that breaks your rock space home network, you can always go back to zero by following the generic 30 30 30 hard reset trick.
This is usually the last resort, and if you still have access to the rock space interface you can always login to try and revert the settings first (This of course supposes you note down the original value before changing it).
Common Reason for Rock space router not working
If none of the above methods worked
All you have to do is to reset your modem. It can be done easily by selecting on the reset button at the back or at the bottom of your router. If you stay on this small button for approximately 20 seconds, (you may have to use a toothpick), then your modem will get restored to the factory settings. What you should keep in mind is that when you reset your modem, you will drop your connection online. So, it's better to take an expert's assistance in this regard.
After reading this blog, I hope now you will know about your Rock Space router login.