1
Ans
9 months ago
Most people nowadays prioritize having a fast internet connection for streaming and data transfer. Several people use wireless routers for fast speed, but due to various obstacles, it is difficult to get WiFi signals in every corner of your home or office.
An amplified wireless extender is used to remove dead zones from the area and to improve the existing wireless signals. It is the device that not only eliminates dead spots but also improves WiFi signal strength.
Before proceeding, you must complete the amped wireless extender setup process. We have shared simple instructions in this article to resolve the issue encountered during amped extender setup.
To update the extender's settings, go to the Amped wireless range extender setup page first. After logging in, you can modify the wireless username and password, as well as update the firmware, among other things.
To log into Amped wireless extender, follow the steps below:
Step 1: Connect and power on the Amped wireless extender.
Step 2: Next, use an Ethernet cable to connect your extender to your device.
Step 3: From your system, launch any internet browser of your choosing. In the address bar of your browser, type setup.ampedwireless.com.
Step 4: A login web page will now appear on the screen.
Step 5: To access the extender's setup page, enter your username and password in the appropriate fields.
Step 6: Click on the login button.
Step 7: To finish the setup process, follow the instructions on the screen.
Step 8: Finally, go to the ampd extender setup page and configure your device according to your needs.
Using the setup.empedwireless.com web address, go through the following instructions for the excited wireless extender setup:
Step 1: Use an Ethernet cable to connect the WAN and modem.
Step 2: Next, link your machine to the router's internet ports using an Ethernet cable.
Step 3: Turn off your router, modem, and computer. Allow all of your equipment to boot up and wait for them to complete the process.
Step 4: Now, in the address bar of your web browser, type http://setup.ampedwireless.com to access the Amped extender login control panel.
Step 5: The Amped wireless extender login page appears on the screen. In the appropriate fields, enter the login credentials.
Step 6: The Amped wireless extender setup panel will then appear on the screen.
Step 7: To continue with the setup process, click the "Start setup" button.
Step 8: Select Automatic Configuration to allow the router wireless settings configuration.
Step 9: Choose a new wireless network name for your home router.
Step 10: When the amped extender setup is complete, a green tick mark will appear.
Here are the steps to setting up an amplified extender using the WPS button:
Step 1: Locate the Power switch on your Amped bluetooth extender. The WPS button is easily accessible on the back of your extender.
Step 2: Locate and press the WPS button.
Step 3: Make sure to press the WPS button on thier router within 2 minutes.
Step 4: Pause for the LED lights on both of thier devices to begin blinking.
Step 5: Eventually, your devices could very well start sync and the configuration process is completed.
Copyright 2018-23 © Router Technical Support | All Rights Reserved