Before you setup Linksys RE4000W extender, you must first know a little bit of functions about this extender device. This RE4000w is compatible with any router or gateway including all the routers that are supplied by the service provider. Moreover, each of these extender consist of 2 Fast Ethernet RJ45 Ports which can be used for two wired devices simultaneously. These simultaneous Dual Band involve 2.4 and 5 GHz bands that help in reducing traffic and maximize speed.
The RE4000W Linksys Extender works by extending the wireless coverage of an area. It does by repeating and redistributing the signal from the router to as far reach of your home. The featured Crossband technology allows wireless bands to receive information over one band and transmit on the other band in order to reduce dropped data packets.
You can setup Linksys RE4000W extender and extend your Internet access in 3 simple steps:
Step 1: Firstly, you need to connect the power cable.
Step 2: Next, you have to plug in the range extender midway between your router and the area without any wifi connection.
Step 3: As the solid light glows on the range extender cover, you will have to connect to the wifi network “Linksys Extender Setup.”
Step 4: In the next step, you have to launch the installed web browser on your system.
Step 5: Once the browser opens up on your screen, you have to enter extender.linksys.com or 192.168.1.1 in the address bar.
Important Note: Optionally, you can even use extender.linksys.setup in case the IP doesn’t works.
Step 6: It will now ask you for the router Username and Password. You can leave the Username tab as blank and type in “admin” in the password’s tab or field.
Step 7: Out from all the available WiFi networks, you will have to choose your Home WiFi Network.
Step 8: Next, you have to punch in your Router’s WiFi password and click on Next button.
Step 9: Here with this step, you can change your LinksysRE4000w Extenders Network Name.
Step 10: Additionally, you will be required to Create Password for your Extender.
Step 11: At the end, you have to register your product by entering in your email information.
Certain times there is a need to reset the device even after you setup Linksys RE4000W extender. In order to reset the Linksys RE4000W to its factory defaults, one must press and hold the Reset button present at the top panel of the device for at least five seconds. Additionally, you may even perform factory reset through the web-based setup page of the router device.
Sometimes, you might encounter an error while setting up your range extender. This is because the setup software will only detect the range extender in its default state. So, to resolve this, you can reset your range extender and then, run the setup software again.
If you find the Contact Customer support screen, you can reset your range extender and then run the Setup Software again.
Quick Tip: You may even download the latest setup software of the range extender from the Linksys RE4000W Downloads and make sure that you are using an updated version.
Before you start setup Linksys RE4000W extender, ensure to have these following things:
So, setup Linksys RE4000W extender is all complete and you are set to go now.