How To Login to a D-Link Router And Access The Setup Page

Login to a D-Link Router:

The D-link web interface is where all the settings are stored and changed. It is the control panel for your router. So you will be required for your D-link router login to make changes to your network.

Things you will need to access the D-link web interface:

• D-link router
• Access to the network (either through LAN or through Wi-Fi).
• A web browser

Here is your step by step guide to your D-Link Router login And Access The Setup Page for configuring and changing the settings.

Ensure that You are Connected to Your D-Link Router

• Connect to its network in order to reach the setup pages of your D-link router. 
• Start the process by connecting the network, either through an Ethernet cable or through Wi-Fi.
• In case you don’t have a W-Fi password, you can always connect to it through an Ethernet cable and you won’t need a password for that.

Go to Your Web Browser and Search 192.168.0.1

• Go to your web browser and search for the router’s IP address into the address field. 
• However, the most common IP address for the link router’s is 192.168.0.1.
• In case it didn’t work, then search for the default D-link router IP address list for your specific model.
• Lastly, a login page for your D-link router’s web interface will pop up on your screen.

Enter the Username and Password for Your D-link Router

• Enter your current username and password in the username and password field and then press Enter or sign in to proceed.
• To know the default login credentials for your D-link router, you can try and search the default D-link credentials. Look for it in case you are unsure about the username and password.
• Or you can also see the credentials on the label at the back of your router.

D-Link Router login is now successfully done and you are ready to configure your D-link router. 

Steps to Configure Your D-link Router

• You can change all the settings available, once you are logged into the D-link admin interface. 
• Just remember to not break the network while configuring your router.

We would recommend you to note down the previous settings in case you can revert it back if troubled.

In Case Your D-link Router or Network Stops Working after a Configuration Change

The button or switch is typically found on the backside of the router, possibly during a hole, however generally conjointly protruding. On some routers, the button is even marked with a label.

If you can’t notice the button it'd be that the WPS button on the router acts as a button once mistreatment the reset sequence.

1. Once a router is power-driven on, press and hold the button for thirty seconds.
2. Whereas still holding the button ironed, undo the ability of the router and hold the button for one more thirty seconds
3. Whereas still holding the button down, activate the ability to the unit once more and hold for one more thirty seconds.

After that, the router ought to boot up with its factory defaults and you'll be able to access it with the default settings. If you don’t remember the default settings, use the search operator higher than to seek out your router and it’s default settings in conjunction with usernames and passwords. If the router remains not operating when a 30-30-30 reset it'd be that it's broken and you ought to think about obtaining a replacement unit or will require a repair.

All broadband routers and modems that are usually used in homes and offices are equipped with a button. This button is usually tiny and hidden, at times within a hole on the backside of the router. The function of the reset button is to get back the device to its default configuration and state, within which the device was when it was new.

We hope the above article helped you in the process of D-Link Router login.