How to Setup Netgear Router for Cable Internet Connection

Setup Netgear Router for Cable Internet Connection:

In this article, you are going to learn the steps for configuring your Netgear router. The steps given below relate to how you can connect to the internet using a genie interface.

So, Take a Look Below to Find Out How to Setup Netgear Router for Cable Internet Connection-

Step 1 : Disconnect the router and the model from the wall outlet. In case, you are using a battery backup, then you must disconnect it for sometime.

Step 2 : Take an ethernet cable and use it to connect your modem to the router. The ethernet cable is generally yellow in colour.

Step 3 : After that to setup netgear router for cable internet connection, take a grey colored ethernet wire to connect the LAN ports of your router to the computer.

Step 4 : Now, you can place the backup battery inside again. Also, reconnect the modem to the power source. Wait for some time so that the light stops blinking and becomes solid.

Step 5 : After that, connect the router back to the power source. Wait a little so that the power light to get solid green.

Step 6 : After that, launch your internet browser and type the IP address of your router in the URL section. Then, press enter.

Step 7 : Login page will open up before you.

Step 8 : Put admin in the username section and enter password in the password blank. Also, you should not forget that both the password and username are case sensitive.

Step 9 : Then, you must move to advanced and then go to setup wizard.

Step 10 : Click on yes and then select Next. Now, the setup procedure is completed. Then, the congratulations page will be displayed in front of you.
Now, open any other website for checking whether the internet is working or not.

So, this was the entire process to setup netgear router for cable internet connection.